Bush Hog 2810

Double tap to zoom

 

Features

Performance Features

  • Wing skids are 3/8” thick for extended wear and outside edges are turned up at 45 degrees to stop heavy ground contact that might damage the sidebands.
  • Center section blades properly align with center wheels to closely cut out the bottom of ditches.
  • Grease fittings and spring steel bushings at axle pivot points for longer life.
  • Free wing float without movement of the hydraulic cylinder rod is 22 degrees down and 45 degrees up.

 

Construction Features

  • Industry first, massive 3-inch output shaft with up to 27% more splines than smaller shafts for maximum transmission of torqueto blade pan.
  • The Patent Pending oil sight gauge takes the guess work out of checking the oil. In less than 10 seconds, all three cutting box oil levels can be checked and rechecked as often as you walk around the machine. Never climb onto the cutter again to check the gearbox oil levels.
  • Bush Hog’s E-Z lube drivelines are quick and easy to service. All grease fittings on the pto CV driveline and wing drivelines align for quick location of grease points. Since all grease fittings on all drivelines are in an up position on every 5th revolution, service times are reduced.

 

Safety Features

  • Highway safety lighting is standard.

 

Product Features

  • Industry first, massive three-inch output shaft with up to 27% more splines than smaller shafts for maximum transmission of torque to blade pan.
  • The Patent Pending oil sight gauge takes the guess work out of checking the oil. In less than 10 seconds, all three cutting box oil levels can be checked and rechecked as often as you walk around the machine. Never climb onto the cutter again to check the gearbox oil levels.
  • Bush Hog’s E-Z lube drivelines are quick and easy to service. All grease fittings on the pto CV driveline and wing drivelines align for quick location of grease points. Since all grease fittings on all drivelines are in an up position on every 5th revolution, service times are reduced.

Specifications

MODELS 2810
CUTTING WIDTH 10' 6"
CUTTING HEIGHT 2″ -14″
CUTTING CAPACITY 4"
TRANSPORT WIDTH* 8' 2"
TRANSPORT HEIGHT** 7' 3"
TRANSPORT LENGTH*** 15' 3"
APPROXIMATE WEIGHT (LB) 5,000
APPROXIMATE TONGUE WEIGHT (LB.) 1,800
MINIMUM TRACTOR PTO HP 60
HITCH "PERMA-LEVEL"
CENTER DECK 11GA OVER 7GA
WING DECKS 7GA
WING CUTTING ANGLES 22° DOWN AND 45° UP
WING LEVEL ADJUSTMENT TURNBUCKLES
SIDEBANDS 1/4″ X 13 1/2″
TRANSFER GEARBOX (HP) 250
CUTTING GEARBOX (HP) 225
INPUT DRIVELINE CATEGORY 6
CUTTING DRIVELINES CATEGORY 4
BLADE HOLDER 7GA ROUND
BLADES 1/2″ X 4″
BLADE TIP SPEED (FPM) 16,268
AXLE SUSPENSION SPRINGS @ EACH AXLE
CENTER & WING HYDRAULICS 3 HOSES STANDARD
SAFETY TOW CHAIN STANDARD
DISTRIBUTION BAFFLES OPTIONAL
PTO DRIVELINE SUPPORT OPTIONAL